IPHost Monitor – MIBs for Cisco 6400 NSP

The Cisco 6400 carrier-class broadband aggregator is a high-performance, scalable service gateway that enables the selection and delivery of broadband network services, virtual private networks (VPNs), and voice- and entertainment-driven traffic over the full suite of access media.

SNMP monitoring is widely used by IPHost clients and makes your network monitoring tasks simple.With the IPHost SNMP tool, you can monitor any SNMP objects of theCisco 6400 NSP.You can select a variable to monitor using the built-in MIB browser that provides youwith all variables supported by theCisco 6400 NSP, their current values and descriptions taken from MIBs.

List of Mibs
for SNMP management and monitoring ofCisco 6400 NSP

  • ATM-MIB
    An Internet Standard MIB for basic management of ATM interfaces and VCCs in ATM end-systems and ATM switches.
  • ATM-RMON-MIB
  • ATM-SOFT-PVC-MIB
  • BRIDGE-MIB
    This MIB module defines a set of managed objects that instrument devices that conform to the IEEE 802.1 standards for MAC-layer bridges.
  • CISCO-6400-CHASSIS-MIB
  • CISCO-ATM2-MIB
  • CISCO-ATM-ACCESS-LIST-MIB
  • CISCO-ATM-ADDR-MIB
  • CISCO-ATM-CONN-MIB
  • CISCO-ATM-IF-MIB
  • CISCO-ATM-IF-PHYS-MIB
  • CISCO-ATM-RM-MIB
  • CISCO-ATM-SERVICE-REGISTRY-MIB
  • CISCO-ATM-SIG-DIAG-MIB
  • CISCO-ATM-SWITCH-ADDR-MIB
  • CISCO-ATM-SWITCH-CUG-MIB
  • CISCO-ATM-TRAFFIC-MIB
  • CISCO-BULK-FILE-MIB
    MIB module for creating and deleting bulk files of SNMP data for file transfer.
  • CISCO-BUS-MIB
  • CISCO-CAR-MIB
    This MIB incorporates objects from the Cisco Rate-limit line interfaces. Its purpose is to provide Weighted Rate-Limit packet filtering information.
  • CISCO-CDP-MIB
    MIB module for management of the Cisco Discovery Protocol in Cisco devices.
  • CISCO-CIRCUIT-INTERFACE-MIB
    MIB module to configure the circuit description for an interface. The circuit description can be used to describe and identify circuits on interfaces like ATM frame-relay etc.
  • CISCO-CONFIG-COPY-MIB
    “This MIB facilitates writing of configuration filesof an SNMP Agent running Cisco’s IOS in the following ways:to and from the net, copying running configurations to startupconfigurations and vice-versa, and copying a configuration(running or startup) to and from the local IOS file system.”
  • CISCO-CONFIG-MAN-MIB
    The MIB represents a model of configuration data that exists in various locations
  • CISCO-DSL-PROVISION-MIB
  • CISCO-FLASH-MIB
    Flash operations MIB module.
  • CISCO-FTP-CLIENT-MIB
    MIB module for invoking Internet File Transfer Protocol (FTP) operations for network management purposes.
  • CISCO-HSRP-EXT-MIB
    This MIB provides an extension to the CISCO-HSRP-MIB which defines Cisco’s “proprietary Hot Standby Routing Protocol (HSRP), defined in RFC2281.
  • CISCO-HSRP-MIB
    This MIB provides a means to monitor and configure the Cisco IOS proprietary Hot Standby Router Protocol (HSRP). Cisco HSRP protocol is defined in RFC2281 (informational rfc).
  • CISCO-IMAGE-MIB
    Router image MIB which identifies the capabilities and characteristics of the image.
  • CISCO-IP-STAT-MIB
    This MIB incorporates objects to provide support for the Cisco IP statistics as implemented in command interfaces.
  • CISCO-LEC-DATA-VCC-MIB
  • CISCO-LEC-EXT-MIB
  • CISCO-LECS-MIB
  • CISCO-LES-MIB
  • CISCO-MEMORY-POOL-MIB
    MIB module for monitoring memory pools.
  • CISCO-NTP-MIB
    This MIB module defines a MIB which provides mechanisms to monitor an NTP server.
  • CISCO-OAM-MIB
  • CISCO-PING-MIB
    This MIB module contains a modified description of the ciscoPingAddress object.
  • CISCO-PNNI-MIB
  • CISCO-PROCESS-MIB
    MIB module to describe active system processes.
  • CISCO-PRODUCTS-MIB
    This MIB module defines the object identifiers that are assigned to various hardware platforms, and hence are returned as values for sysObjectID.
  • CISCO-RHINO-MIB
  • CISCO-SYSLOG-MIB
    MIB module to describe and store the system messages generated by the IOS.
  • CISCO-TCP-MIB
    An extension to the IETF MIB module for monitoring TCP implementations.
  • HC-RMON-MIB
    MIB module for managing remote monitoring device implementations. This MIB module augments the original RMON MIB as specified in RFC 1757 and RFC 1513 and RMON2 MIB as specified in RFC 2021.
  • IF-MIB
    MIB module for managing remote monitoring device implementations. This MIB module augments the original RMON MIB as specified in RFC 1757 and RFC 1513 and RMON2 MIB as specified in RFC 2021.
  • INT-SERV-GUARANTEED-MIB
    MIB module to describe the Guaranteed Service of the Integrated Services Protocol
  • INT-SERV-MIB
    MIB module to describe the Integrated Services Protocol
  • LAN-EMULATION-CLIENT-MIB
    MIB for configuration, performance, and fault management of ATM LAN Emulation Clients
  • OLD-CISCO-CHASSIS-MIB
    This Management Information Base module contains information regarding polling the chassis information (specifically the chassis serial number) from Cisco routers and switches. tarting with IOS 12.0
  • OLD-CISCO-INTERFACES-MIB
  • OLD-CISCO-IP-MIB
  • OLD-CISCO-SYS-MIB
  • OLD-CISCO-TCP-MIB
  • OLD-CISCO-TS-MIB
  • PNNI-MIB
    MIB module for managing ATM Forum PNNI routing.
  • RFC1213-MIB
    This RFC defines the second version of the Management Information Base (MIB-II) for use with network management protocols in TCP/IP-based internets.
  • RMON2-MIB
    MIB module for managing remote monitoring device implementations. This MIB module augments the original RMON MIB as specified in RFC 1757.
  • RMON-MIB
    This Management Information Base contains standard information relating to Remote Network Monitoring.
  • RSVP-MIB
    The Resource Reservation Protocol (RSVP) Management Information Base (MIB) feature introduces three new MIBs. The MIBs allow users to use SNMP to access objects belonging to RSVP, Integrated Services, and Guaranteed Services.
  • SMON-MIB
    MIB module for managing remote monitoring device implementations for Switched Networks.
  • SNMP-FRAMEWORK-MIB
    The SNMP Management Architecture MIB.
  • SNMP-NOTIFICATION-MIB
    This MIB module defines MIB objects which provide mechanisms to remotely configure the parameters used by an SNMP entity for the generation of notifications.
  • SNMP-PROXY-MIB
  • SNMP-TARGET-MIB
    This MIB module defines MIB objects which provide mechanisms to remotely configure the parameters used by an SNMP entity for the generation of SNMP messages.
  • SNMP-USM-MIB
    The management information definitions for the SNMP User-based Security Model.
  • SNMPv2-MIB
    This MIB module defines MIB objects for SNMPv2 entities.
  • SNMP-VACM-MIB
    The management information definitions for the View-based Access Control Model for SNMP.
  • SOURCE-ROUTING-MIB
    This MIB module defines MIB objects for Station Source Routing.
  • TCP-MIB
    MIB module for managing TCP implementations.
  • UDP-MIB
    MIB module for managing UDP implementations.

You can start Cisco 6400 NSP monitoring using free 30-day trial version of IPHost Network Monitor right now.Witn IPHost SNMP monitor you can monitor network performance, audit network usage, detect network faults, or inappropriate access. The IPHost’s SNMP monitor can communicate and interact with any SNMP-enabled device.

Free 30-day trial version of IPHost Network Monitor is available. During your trial you can get support by e-mail, please use contact form to send all your inquiries on IPHost Network Monitor features and purchase.

Windows Interface Screenshot Web Interface Screenshot
Windows Interface Screenshot Web Interface Screenshot
 

Download the free trial of IPHost Network Monitor and start to monitor your network and vital applications in a few minutes.



IPHost Network Monitor 5.3 build 14150 of December 25, 2020. File size: 68MB


Comments are closed.